2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL GENERATOR ASSEMBLY

A115420E01
  1. Provisionally install the generator with fixing bolt B.

  1. A115419E01
    Provisionally install the fan belt adjusting slider with fan belt adjusting slider fixing bolts A and B, then move the generator toward the cylinder block and tighten bolt B.

    Torque:
    11 N*m{ 112 kgf*cm , 8.1 ft.*lbf }

  1. A115418
    Install the connector and wire harness clamp.

  1. Install terminal B with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7.2 ft.*lbf }

  1. Install the terminal cap.


2. INSTALL FAN AND GENERATOR V BELT
  1. Provisionally install the fan and generator V belt onto each pulley.

    NOTICE:
    Make sure that the V-belt is securely fitted into the rib groove of the pulley.


3. ADJUST FAN AND GENERATOR V BELT

  1. A116198E01
    Insert an adjusting bar between the engine mounting bracket and generator assembly. Push the adjusting bar towards the vehicle front to adjust the generator V belt tension.

    NOTICE:
    Do not insert the adjusting bar between the camshaft timing oil control valve assembly and generator assembly. It could damage the camshaft timing oil control valve assembly.

  1. A116197E01
    First tighten bolt A, then tighten bolt B.

    Torque:
    19 N*m{ 189 kgf*cm , 14 ft.*lbf } for bolt A
    54 N*m{ 551 kgf*cm , 40 ft.*lbf } for bolt B


4. INSPECT FAN AND GENERATOR V BELT

  1. A116200E01
    Check the V belt deflection and tension.

    Deflection:
    Item
    Specified Condition
    New belt
    7.0 to 8.5 mm (0.28 to 0.33 in)
    Used belt
    11 to 13 mm (0.43 to 0.51 in)

    Tension:
    Item
    Specified Condition
    New belt
    539 to 637 N (55 to 65 kg, 121 to 143 ld)
    Used belt
    245 to 392 N (25 to 40 kg, 55 to 88 ld)

    If the belt deflection is not as specified, adjust it.

    HINT:
    1. Check the V belt deflection at the specified point.
    2. Check the drive belt deflection at the specified point.
    3. When installing a new belt, set its tension to the specified value.
    4. When inspecting a belt which has been used for over 5 minutes, apply the Used Belt specifications.
    5. When reinstalling a belt which has been used for over 5 minutes, adjust its deflection and tension to the intermediate values of each Used Belt specification.
    6. V-ribbed belt tension and deflection should be checked after 2 revolutions of engine cranking.
    7. When using a belt tension gauge, confirm its accuracy by using a master gauge first.


5. INSTALL ENGINE UNDER COVER RH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Aug 2005)PRECAUTION (from Aug 2005) →