REASSEMBLY
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
Place the drive end frame on the generator rotor assembly.
- NOTICE:
- Do not drop the generator rotor assembly.
Install the generator rotor assembly and plate retainer.
Using a 30 mm socket wrench and press, slowly press in the rectifier end frame.

Install the 4 nuts and clip cord.

- Torque:
- 4.5 N*m{ 46 kgf*cm , 40 in.*lbf }
Install the 3 terminal insulators onto the rectifier end frame.
| 2. INSTALL GENERATOR HOLDER WITH RECTIFIER |
![]() ![]() |
Install the generator rectifier holder with the 3 screws.
- Torque:
- 2.0 N*m{ 20 kgf*cm , 17 in.*lbf }
| 3. INSTALL GENERATOR REGULATOR ASSEMBLY |
![]() ![]() |
Install the generator regulator assembly with the 2 screws.
- Torque:
- 2.0 N*m{ 20 kgf*cm , 17 in.*lbf }
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() ![]() |
Install the plate seal.
Install the generator brush holder assembly with the 3 screws.
- Torque:
- 2.0 N*m{ 20 kgf*cm , 17 in.*lbf }
Install the brush cover onto the generator brush holder assembly.
Install the rear end cover with the 2 nuts.
- Torque:
- 4.4 N*m{ 45 kgf*cm , 39 in.*lbf }
Install the rectifier plate with the nut and screw.
- Torque:
- 4.4 N*m{ 45 kgf*cm , 39 in.*lbf } for nut
- Torque:
- 3.8 N*m{ 39 kgf*cm , 34 in.*lbf } for bolt
Install the terminal insulator with the nut.
- Torque:
- 4.1 N*m{ 42 kgf*cm , 36 in.*lbf }
| 5. INSTALL GENERATOR PULLEY |
![]() ![]() |
- SST
- 09820-63010
(09820-06010, 09820-06020)
- HINT:
SST 1-A and B
09820 - 06010
SST 2
09820 - 06020
Install the generator pulley to the generator rotor shaft by tightening the generator pulley nut by hand.
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
- NOTICE:
- Check that the SST is securely fitted onto the generator rotor shaft.
Mount SST 2 in a vise.

Insert SST 1-A and B into SST 2, and attach the generator pulley nut to SST 2.
Tighten the generator pulley nut by turning SST 1-A in the direction shown in the illustration.

- Torque:
- 133 N*m{ 1,356 kgf*cm , 98 ft.*lbf }
Remove the generator from SST 2.
Turn SST 1-B, and remove SST 1-A and B.

Turn the generator pulley, and check that the generator pulley moves smoothly.




