2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. REMOVE REAR WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


3. DISCONNECT PARKING BRAKE CABLE ASSEMBLY

C112609
  1. Disconnect the cable end from the rear disc brake cylinder operation lever.

  1. C112608E01
    Insert offset wrench 14 all the way into the casing cap clip to flex the clip claws and disconnect the parking brake cable.


4. SEPARATE REAR FLEXIBLE HOSE

C108943
  1. Remove the union bolt and gasket and separate the flexible hose from the disc brake cylinder.


5. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

C108944
  1. Fix the slide pin with a spanner, remove the 2 bolts and remove the disc brake cylinder.


6. REMOVE REAR DISC BRAKE PAD KIT (PAD ONLY)

C108945
  1. Remove the 2 disc brake pads from the disc brake cylinder mounting.


7. REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT
  1. Remove the anti squeal shim from each brake pad.


8. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE

C125280
  1. Remove the 2 disc brake pad support plates from the disc brake cylinder mounting.


9. REMOVE REAR DISK BRAKE REAR CYLINDER SLIDE PIN

C116959
  1. Remove the 2 slide pins from the disc brake cylinder mounting.


10. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH

C116887E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the slide bush from the slide pin.


11. REMOVE REAR DISC BRAKE BUSH DUST BOOT

C108949
  1. Remove the 2 dust boots from the disc brake cylinder mounting.


12. REMOVE REAR DISC BRAKE CYLINDER MOUNTING

C108950
  1. Remove the 2 bolts and remove the disc brake cylinder mounting from the axle beam.


13. REMOVE REAR DISC

C108951E01
  1. Place matchmarks on the disc and axle hub and remove the disc.

← COMPONENTS (from Aug 2005)DISASSEMBLY (from Aug 2005) →