REASSEMBLY
Removal / installation · Vehicles built from Aug 2005
| 1.
TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG |
|
| 2.
INSTALL REAR DISC BRAKE BLEEDER PLUG CAP |
|
| 3.
INSTALL PISTON SEAL |
 |
Apply lithium soap base glycol grease to a new piston seal.
Install the piston seal onto the disc brake cylinder.
- NOTICE:
- Securely install the piston seal into the groove of the disc brake cylinder.
| 4.
INSTALL CYLINDER BOOT |
 |
Apply lithium soap base glycol grease to the piston and a new cylinder boot.
- Install the cylinder boot onto the piston, as shown in the illustration.
- NOTICE:
- Do not install the cylinder boot after installing the piston into the disc brake cylinder.
| 5.
INSTALL REAR DISC BRAKE PISTON |
 |
Install the seal portion of the cylinder boot into the groove portion of the disc brake cylinder.
- NOTICE:
- Securely install the seal portion of the cylinder boot into the groove portion of the disc brake cylinder.
- Using SST, screw the piston to the end by turning it clockwise as far as possible.
- SST
- 09960-10010
(09963-00400)
- NOTICE:
- Securely install the seal portion of the cylinder boot into the groove portion of the piston.
- Do not damage the piston and cylinder boot.
- Using SST, slowly turn the piston counterclockwise so that the piston groove is placed in the position shown in the illustration.
- HINT:
- When installing the disc brake cylinder onto the disc cylinder mounting, align the piston groove with the protruding portion of the brake pad.
- Make sure that the cylinder boot is securely installed into the groove of the disc brake cylinder and disc brake piston.