2005-2008 Yaris · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT PAD LINING THICKNESS

C129765E01
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    9.0 mm (0.354 in.)

    Minimum thickness:
    2.0 mm (0.079 in.)

    If the pad lining thickness is equal to the minimum thickness or less, replace the disc brake pad kit.


INSPECT DISC THICKNESS

C116894E01
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    9.0 mm (0.354 in.)

    Minimum thickness:
    7.0 mm (0.276 in.)

    If the disc thickness is less than the minimum, replace the rear disc.


INSPECT DISC RUNOUT
  1. Check the bearing play in the axial direction and check for the axle hub runout (Click here).

  1. Provisionally fasten the rear disc together with the hub nuts.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

  1. C108954E01
    Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.

    Maximum disc runout:
    0.15 mm (0.0059 in.)

    If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, grind the disc. If the disc thickness is less than the minimum, replace the rear disc.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →