ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT FRONT AXLE HUB BEARING |
Remove the front wheel.
Separate the front disc brake caliper (Click here).
Remove the front disc (Click here).
Inspect the axle hub backlash.

Using a dial indicator, check the backlash near the center of the axle hub.
- Maximum:
- 0.05 mm (0.0020 in.)
Inspect the axle hub runout.

Using a dial indicator, check the runout of the surface of the axle hub.
- Maximum:
- 0.05 mm (0.0020 in.)
Install the front disc (Click here).
Install the front disc brake caliper (Click here).
Install the front wheel.
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }
| INSPECT REAR AXLE HUB BEARING |
Remove the rear wheel.
for Rear Drum Brake:
Remove the rear brake drum (Click here).
for Rear Disc Brake:
Disconnect the parking brake cable (Click here).
Separate the rear disc brake caliper (Click here).
Remove the rear disc (Click here).
Inspect the axle hub and bearing backlash.

Using a dial indicator, check the backlash near the center of the axle hub.
- Maximum:
- 0.05 mm (0.0020 in.)
Inspect the axle hub and bearing runout.

Using a dial indicator, check the runout of the surface of the axle hub.
- Maximum:
- 0.07 mm (0.0028 in.)
for Rear Drum Brake:
Install the rear brake drum.
for Rear Disc Brake:
Install the rear disc (Click here).
Install the rear disc brake caliper (Click here).
Connect the parking brake cable (Click here).
Install the rear wheel.
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }
