2005-2008 Yaris · Service Manual BRAKE

U0073/94 Control Module Communication Bus OFF

Diagnostic trouble codes · Vehicles built from Aug 2005

Also covers:

DESCRIPTION

DTC No.
DTC Detecting Conditions
Trouble Areas
U0073/94
When either of following conditions detected:
  1. After data output from skid control ECU completed, output continues for 5 seconds or more.
  2. Bus off condition occurs once or more per 0.1 second 10 times in succession.
CAN communication system
U0100/65
When either of following conditions detected:
  1. When IG1 terminal voltage 10 V or more and vehicle speed 15 km/h (9 mph) or more, data cannot be sent to ECM.
  2. When IG1 terminal voltage 10 V or more and vehicle speed 15 km/h (9 mph) or more, either of following conditions occur 10 times in succession.
    1. Data cannot be sent to ECM occurs once or more within 5 seconds.
    2. Data from ECM cannot be received occurs once or more within 5 seconds.
CAN communication system
U0123/62
When either of following conditions detected:
  1. When IG1 terminal voltage 10 V or more, data from yaw rate sensor cannot be received for 1 second or more.
  2. When IG1 terminal voltage 10 V or more, following condition occurs 10 times in succession.
    1. Data from yaw rate sensor cannot be received occurs once or more within 5 seconds.
CAN communication system
U0124/95
When either of following conditions detected:
  1. When IG1 terminal voltage 9.5 V or more, data from deceleration sensor cannot be received for 1 second or more.
  2. When IG1 terminal voltage 9.5 V or more, following condition occurs 10 times in succession.
    1. Data from deceleration sensor cannot be received occurs once or more within 5 seconds.
CAN communication system
U0126/63
When either of following conditions detected:
  1. When IG1 terminal voltage 10 V or more, data from steering sensor cannot be received for 1 second or more.
  2. When IG1 terminal voltage 10 V or more, following condition occurs 10 times in succession.
    1. Data from steering sensor cannot be received occurs once or more within 5 seconds.
CAN communication system

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Check if the same DTC(s) is output (Click here).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPAIR CAN COMMUNICATION SYSTEM


← C1290/66 Steering Angle Sensor Zero Point Malfunction (from Aug 2005)ABS Warning Light Remains ON (from Aug 2005) →