2005-2008 Yaris · Service Manual BRAKE

U0073/94 Control Module Communication Bus OFF

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

The skid control ECU exchanges signals with the ECM, steering angle sensor, yaw rate and deceleration sensor, power steering ECU, main body ECU and combination meter via CAN communication.
DTC No.
DTC Detecting Conditions
Trouble Areas
U0073/94
When either of following conditions detected:
  1. Bus off conditions continue for approximately 1 second.
  2. Bus off condition occurs 10 times in 8 seconds period.
CAN communication system
U0100/65
When engine speed 500 rmp or more, vehicle speed 15 km/h (9 mph) or more, and power supply voltage normal (9.7 V or more), skid control ECU receives no ECM data or received message not correct for approximately 1.2 seconds.
CAN communication system
U0123/62
Supplied volage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds.
CAN communication system
U0126/63
Supplied volage normal (9.7 V or more), skid control ECU receives no steering angle sensor data for 0.1 seconds.
CAN communication system

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Check if the same DTC(s) is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPAIR CAN COMMUNICATION SYSTEM


← C1370/73 Engine or Transmission System Matching Error (from Nov 2005)ABS Warning Light Remains ON (from Nov 2005) →