2005-2008 Yaris · Service Manual BRAKE

C1370/73 Engine or Transmission System Matching Error

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

This DTC is set by the skid control ECU when the ECM is replaced with a one that has different engine and transmission information from the information stored in the skid control ECU.
This DTC is also set when the ABS and TRACTION actuator (skid control ECU) is replaced with a one that has different engine and transmission information from the information stored in the ECM.
DTC No.
DTC Detecting Condition
Trouble Areas
C1370/73
Information relating to engine, transmission, drive source or destination stored in ECM does not match information stored in skid control ECU.
  1. ECM
  2. ABS and TRACTION actuator (skid control ECU)

HINT:
As with the calibration, clear the zero point calibration data and enter test mode. The system returns to normal when the correct data is received from the ECM.


INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. REPLACE ECM
  1. Replace the ECM.

    HINT:
    1. 1KR-FE: (Click here)
    2. 1ND-TV: (Click here)
    3. 2SZ-FE: (Click here)


NEXT


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1336/39 Zero Point Calibration of Acceleration Sensor Undone (from Nov 2005)U0073/94 Control Module Communication Bus OFF (+ U0100/65, U0123/62, U0126/63) (from Nov 2005) →