2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

A108477
  1. Remove the nut, and disconnect the lead wire from the magnetic switch terminal.

  1. Remove the 2 nuts holding the magnetic switch onto the starter housing.

  1. A117326
    Pull the magnetic switch and while lifting the front part of the magnetic switch, release the plunger hook from the driver lever, then remove the magnetic switch.


2. REMOVE STARTER YOKE ASSEMBLY

A104561
  1. Remove the 2 through bolts and end cover.

  1. A117335
    Hold the starter drive housing in a vise between alminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Remove the plate and 4 brush springs.

  1. Disconnect the 4 brushes, and remove the brush holder.

  1. Remove the starter yoke assembly.


3. REMOVE ARMATURE

A117328
  1. Pull the armature together with the drive lever out of the starter housing.

  1. Remove the drive lever from the armature.


4. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A104563
    Using a screwdriver, tap the inside stop collar toward the armature.

  1. A104564
    Using a screwdriver, pry off the snap ring.

  1. Pull the stop collar and starter clutch out of the armature.

← REMOVAL (from Aug 2005)INSPECTION (from Aug 2005) →