2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. REMOVE GENERATOR PULLEY

A104549E01
SST
09820-63010   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820 - 06010
SST 2
09820 - 06020

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is securely fitted onto the generator rotor shaft.

  1. A104550E02
    Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the generator pulley nut to SST 2.

  1. A033335E01
    To loosen the generator pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the generator pulley nut by more than one-half turn.

  1. Remove the generator from SST 2.

  1. A104551E01
    Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the generator pulley nut and generator pulley.


2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

A117299
  1. Remove the nut and terminal insulator.

  1. Remove the nut, screw and rectifier plate.

  1. Remove the 2 nuts and rear end cover.

  1. A117359
    Remove the brush cover from the generator brush holder assembly.

  1. Remove the 3 screws and generator brush holder assembly.

  1. Remove the plate seal.


3. REMOVE GENERATOR REGULATOR ASSEMBLY

A117300
  1. Remove the 2 screws and generator regulator assembly.


4. REMOVE GENERATOR HOLDER WITH RECTIFIER

A117373
  1. Remove the 3 screws and generator holder with rectifier.


5. REMOVE GENERATOR ROTOR ASSEMBLY

A117374
  1. Remove the 3 terminal insulators from the rectifier end frame.

  1. Remove the 4 nuts.

  1. A104552E01
    Using SST, remove the rectifier end frame.
    SST
    09286-46011  

  1. Remove the plate retainer.

  1. Remove the generator rotor assembly from the drive end frame.

    NOTICE:
    Do not drop the generator rotor assembly.

    HINT:
    If the generator rotor is engaged too firmly, gently tap the generator rotor shaft to remove it using a plastic hammer.

← REMOVAL (from Aug 2005)INSPECTION (from Aug 2005) →