REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 |
Remove the 2 screws.

Disengage the 3 claws and remove the instrument panel under cover.
| 3. SEPARATE CLUTCH MASTER CYLINDER ASSEMBLY |
![]() ![]() |
Remove the spring and clip and remove the push rod clevis pin.
Remove the 2 nuts and separate the push rod clevis from the clutch pedal.
| 4. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY |
![]() ![]() |
Disconnect the clutch start switch connector.
Remove the 2 bolts and the clutch pedal support.
| 5. REMOVE CLUTCH PEDAL SUB-ASSEMBLY |
![]() ![]() |
Remove the bolt and nut.
Remove the clutch pedal from the clutch pedal support.
| 6. REMOVE CLUTCH PEDAL SHAFT COLLAR |
![]() ![]() |
Remove the 2 bushes and collar from the clutch pedal.
| 7. REMOVE CLUTCH PEDAL NO.1 CUSHION |
![]() ![]() |
Remove the clutch pedal No. 1 cushion from the clutch pedal.
| 8. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH |
![]() ![]() |
Using an 8 mm hexagon wrench and a hammer, remove the clevis bush.
| 9. REMOVE CLUTCH PEDAL PAD |
Remove the clutch pedal pad from the clutch pedal.
| 10. REMOVE CLUTCH PEDAL STOPPER |
| 11. REMOVE CLUTCH START SWITCH ASSEMBLY |
![]() ![]() |
Remove the nut and the clutch start switch.
| 12. REMOVE CLUTCH PEDAL STOPPER BOLT |
![]() ![]() |
Loosen the lock nut and remove the clutch pedal stopper bolt.








