2005-2008 Yaris · Service Manual TRANSMISSION

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.

  1. C127617E01
    Check that the pedal height is correct.

    Pedal height from floor:
    149.2 to 159.2 mm (5.874 to 6.268 in.) 1KR-FE/2SZ-FE
    159.3 to 169.3 mm (6.272 to 6.665 in.) 1ND-TV

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }


INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY

D031462E01
  1. Check that the pedal free play and push rod play are correct.

    1. Depress the pedal until clutch resistance begins to be felt.

      Pedal free play:
      7.0 to 14.0 mm (0.276 to 0.551 in.)

    2. Gently depress the pedal until the resistance begins to increase a little.

      Push rod play at pedal top:
      0.2 to 6.8 mm (0.008 to 0.268 in.)


INSPECT AND ADJUST CLUTCH RELEASE POINT

CL00512E05
  1. Check the clutch release point.

    1. Pull the parking brake lever and install a wheel stoppers.

    2. Start the engine and run it at idle.

    3. Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears come into contact.

    4. Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.

      Standard distance:
      25 mm (0.98 in.) or more (From pedal stroke end position to release point)

      If the distance is not as specified, perform the following operations.
      1. Check pedal height.
      2. Check push rod play and pedal free play.
      3. Bleed the clutch line.
      4. Check the clutch cover assembly and disc assembly.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →