2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

C125988E01
  1. Install the lock nut onto the push rod.

  1. Install the push rod clevis.

  1. Tighten the lock nut and check the dimension A is same as the dimension A that has been measured.


2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

C106350
  1. Install the clutch master cylinder with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Apply MP grease to the contact surface of the hole pin and clevis bush.

  1. Connect the clevis to the clutch pedal with the hole pin.

    HINT:
    Install the hole pin from the right side of the vehicle.

  1. Install the clip onto the hole pin.


3. INSTALL CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C118344
SST
09023-00101  
  1. Using SST, connect the flexible hose tube.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }


4. INSTALL CLUTCH RESERVOIR TUBE

C118343
  1. Connect the clutch reservoir tube with the clip to the clutch master cylinder.


5. ADD BRAKE FLUID

6. BLEED CLUTCH PIPE LINE

7. INSPECT BRAKE FLUID

8. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.

  1. C106345E01
    Check that the pedal height is correct.

    Pedal height from floor:
    144.4 to 154.4 mm (5.685 to 6.079 in.) 1KR-FE/2NZ-FE
    159.2 to 169.2 mm (6.268 to 6.661 in.) 1NZ-FE

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }


9. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

  1. B114572
    Engage the 3 claws and install the instrument panel under cover.

  1. Tighten the 2 screws.

← REMOVAL (from Aug 2005)COMPONENTS (from Nov 2005) →