2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2005

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL FRONT DOOR BELT MOULDING

  1. B114401
    for 5 Door:

    1. Engage the 5 claws and the clip and install a new front door belt moulding.

    2. B114397E02
      Remove the protective tape.

  1. B114614
    for 3 Door:

    1. Engage the 5 claws and the clip and install a new front door belt moulding.

    2. B114612E01
      Remove the protective tape.


2. INSTALL FRONT DOOR WINDOW FRAME REAR MOULDING (for 3 Door)

  1. B114606E01
    Clean the attachment surface.

    1. Using an infrared light, heat the adhesive remaining on the body.

      NOTICE:
      Do not burn yourself with the heated body or infrared light.

    2. Using a shop rag or piece of cloth, rub the remaining adhesive off the body.

    3. Using a non-residue solvent, clean the attachment surface.

  1. Apply new double-sided adhesive tape to the front door window frame rear moulding.

    Tape size: 
    Area
    t
    W
    H
    A
    0.8 mm (0.032 in.)
    5 mm (0.197 in.)
    340 mm (13.386 in.)
    B
    0.8 mm (0.032 in.)
    5 mm (0.197 in.)
    376 mm (14.803 in.)

  1. B114607
    Engage the 2 clips and the claw and install the front door window frame rear moulding.


3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

B118045
  1. Engage the claw, then install the outer rear view mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power mirror:
    Connect the connector.


4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Install the front door trim board sub-assembly (Click here).

  1. w/o Power Window:

    1. Install the front door trim board sub-assembly (Click here).


5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.

  1. B116947E01
    Install the front door window regulator handle with clip at the angle shown in the illustration.


6. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL
  1. w/ Power Window:

    1. Install the front door upper armrest base upper panel (Click here).

  1. w/o Power Window:

    1. Install the front door armrest base upper panel (Click here).


7. INSTALL FRONT DOOR ARMREST COVER

B116818
  1. for 5 Door:
    Engage the 8 claws and 3 clips and install the door armrest cover.

  1. B116851
    for 3 Door:
    Engage the 12 claws and 4 clips and install the door armrest cover.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REMOVAL (from Aug 2005)COMPONENTS (from Jan 2006) →