2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT BUMPER COVER

  1. B134799E01
    Apply protective tape, as shown in the illustration.

  1. B134803
    Remove the 7 screws and 3 bolts.

  1. Remove the 2 screw grommets.

  1. Remove the 6 clips.

  1. B134801
    w/ Fog Light:

    1. Disengage the 6 claws and remove the front bumper cover.

    2. Disconnect the 2 fog light connectors.

  1. B134800
    w/o Fog Light:

    1. Disengage the 6 claws and remove the front bumper cover.

  1. B134823
    Remove the 2 clips and the screw grommet.


3. REMOVE FRONT BUMPER SIDE RETAINER LH

  1. B134807
    Remove the screw and the bolt.

  1. Disengage the 2 claws and remove the front bumper side retainer.


4. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE RADIATOR SUPPORT UPPER ABSORBER

  1. B134808
    Using a screwdriver, disengage the 6 claws and remove the radiator support upper absorber.


6. REMOVE THERMISTOR ASSEMBLY (w/ Air Conditioning System)

  1. B134809
    Remove the 2 clamps and the thermistor.


7. REMOVE RADIATOR SIDE AIR SEAL LH

  1. B138500
    for G. C. C. Countries:

    1. w/o Air Conditioning System (LH Side Only):

      1. Remove the clamp.

    2. B134811
      Disengage the 4 claws and remove the radiator side air seal.

  1. B134810
    except G. C. C. Countries:

    1. Disengage the 2 claws and remove the radiator side air seal.


8. REMOVE RADIATOR SIDE AIR SEAL RH

HINT:
Use the same procedure as for the LH side.


9. REMOVE RADIATOR SUPPORT EXTENSION LH (w/ Radiator Support Extension)

  1. B138499
    w/o Air Conditioning System (LH Side Only):

    1. Remove the clamp.

  1. B134812
    Disengage the 2 claws and remove the radiator extension.


10. REMOVE RADIATOR SUPPORT EXTENSION RH (w/ Radiator Support Extension)

HINT:
Use the same procedure as for the LH side.


11. REMOVE NO. 2 ENGINE ROOM WIRE

  1. B134815
    w/ Fog Light:

    1. Using a clip remover, remove the 7 clamps and the No. 2 engine room wire.

  1. B134814
    w/o Fog Light:

    1. Using a clip remover, remove the 6 clamps and the No. 2 engine room wire.


12. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

  1. B134817
    for G. C. C. Countries:

    1. Remove the 6 bolts, 4 nuts and the front bumper reinforcement.

  1. B134816
    except G. C. C. Countries:

    1. Remove the 6 bolts, 4 nuts and the front bumper reinforcement.


13. REMOVE FRONT BUMPER STONE DEFLECTOR BRACKET

B134818

HINT:
Use the same procedure for both sides.

  1. Remove the 2 nuts and the front bumper stone deflector bracket.


14. REMOVE HEADLIGHT ASSEMBLY

HINT:
Use the same procedure as for the RH side (Click here).


15. REMOVE WINDSHIELD WASHER JAR ASSEMBLY

  1. B134819
    Remove the 2 bolts and windshield washer jar.


16. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY LH

HINT:
Use the same procedure as for the LH side.


17. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY RH

  1. B134820
    Remove the 4 bolts and the front bumper arm.

← COMPONENTS (from Jan 2006)DISASSEMBLY (from Jan 2006) →