2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2005

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116942
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.


3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Remove the rear door trim board sub-assembly (Click here).

  1. w/o Power Window:

    1. Remove the rear door trim board sub-assembly (Click here).


4. REMOVE REAR DOOR BELT MOULDING

  1. B114404E01
    Apply protective tape to the door panel in the area around the rear door belt moulding.

  1. B114405E01
    Using a moulding remover, disengage the 5 claws and the clip and remove the rear door belt moulding.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →