2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL REAR BUMPER ARM SUB-ASSEMBLY LH (for G. C. C. Countries:)

  1. B114631
    Install the rear bumper arm with the 3 bolts.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }


2. INSTALL REAR BUMPER ARM SUB-ASSEMBLY RH (for G. C. C. Countries)

HINT:
Use the same procedure as for the LH side.


3. INSTALL REAR BUMPER REINFORCEMENT

  1. B114391
    except G. C. C. Countries:

    1. Install the rear bumper reinforcement with the 6 bolts.

      Torque:
      19 N*m{ 195 kgf*cm , 14 ft.*lbf }

  1. B114620
    for G. C. C. Countries:

    1. Install the rear bumper reinforcement with the 4 nuts.

      Torque:
      19 N*m{ 195 kgf*cm , 14 ft.*lbf }


4. INSTALL REAR BUMPER SHIELD CENTER BRACKET (for G. C. C. Countries)

B114632

HINT:
Use the same procedure to install all the rear bumper shield center bracket.

  1. Engage the 4 claws and install the rear bumper shield center bracket.


5. INSTALL REAR BUMPER SIDE RETAINER LH

  1. B114390
    Engage the 2 claws and install the rear bumper side retainer.

  1. Tighten the screw.


6. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.


7. INSTALL REAR BUMPER COVER

  1. B114623E01
    Connect the license plate light connector.

  1. Engage the 4 claws and install the rear bumper.

  1. B114624
    Engage the 8 claws.

  1. B126917
    w/ Floor Under Cover:

    1. Tighten the 2 bolts.

    2. Install the clip.

  1. B114629
    w/o Floor Under Cover:

    1. Tighten the 2 bolts.

    2. Install the 2 clips.

  1. B114630E01
    Remove the protective tape.


8. INSTALL FLOOR UNDER COVER (w/ Floor Under Cover)

  1. B114627
    Install the rear bumper retainer lower with the 5 clips.


9. INSTALL REAR BUMPER SIDE SEAL LH

  1. B114386
    Install the rear bumper side seal with the 2 clips.


10. INSTALL REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Aug 2005)COMPONENTS (from Nov 2006) →