2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2005

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

2. REMOVE FRONT DOOR ARMREST COVER

B116818
  1. for 5 Door:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and 3 clips and remove the door armrest cover.

  1. B116851
    for 3 Door:
    Disengage the 12 claws and 3 clips and remove the door armrest cover.


3. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL
  1. w/ Power Window:

    1. Remove thre front door armrest base upper panel (Click here).

  1. w/o Power Window:

    1. Remove thre front door armrest base upper panel (Click here).


4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116850
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the front door window regulator handle and clip.

  1. Remove the window regulator handle plate.


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Remove the front door trim board sub-assembly (Click here).

  1. w/o Power Window:

    1. Remove the front door trim board sub-assembly (Click here).


6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

B118045
  1. w/ Power mirror:
    Disconnect the connector.

  1. Remove the 3 nuts, disengage the claw and remove the outer rear view mirror.


7. REMOVE FRONT DOOR BELT MOULDING

  1. B114397E02
    for 5 Door:

    1. Apply protective tape to the door panel in the area around the front door belt moulding.

    2. B114398E02
      Using a moulding remover, disengage the 5 claws and the clip and remove the front door belt moulding.

  1. B114612E01
    for 3 Door:

    1. Apply protective tape to the door panel in the area around the front door moulding.

    2. B114613E01
      Using a moulding remover, disengage the 5 claws and remove the front door belt moulding.


8. REMOVE FRONT DOOR GLASS RUN

B116826
  1. Remove the front door glass run.


9. REMOVE NO. 1 BLACK OUT TAPE

  1. B108308
    Using an infrared light, heat the No. 1 black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →