2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2005

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL NO. 2 BLACK OUT TAPE
  1. Application precautions (Click here).

  1. Clean the attachment surface (Using an infrared light) (Click here).

  1. Clean the attachment surface (Using a tape removal disc) (Click here).

  1. Apply new No. 2 black out tape to the positions shown in the illustration.

    B114639E01

    Installation position:
    Mark
    Measurement (along surface)
    a
    +-1 mm (+-0.039 in.)
    b
    0 to 1.8 mm (0 to 0.071 in.)
    c
    2 mm (0.079 in.)
    d
    1.2 to 3.2 mm (0.047 to 0.126 in.)
    e
    2 to 4 mm (0.079 to 0.157 in.)


2. INSTALL REAR DOOR GLASS RUN

B116877
  1. Install the rear door glass run.


3. INSTALL REAR DOOR BELT MOULDING

  1. B114406
    Engage the 5 claws and the clip and install a new rear door belt moulding.

  1. B114404E01
    Remove the protective tape.


4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Install the rear door trim board sub-assembly (Click here).

  1. w/o Power Window:

    1. Install the rear door trim board sub-assembly (Click here).


5. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.

  1. B121530E01
    Install the rear door window regulator handle with the clip at the angle shown in the illustration.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REMOVAL (from Aug 2005)COMPONENTS (from Jan 2006) →