2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2005

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116942
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.


3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Remove the rear door trim board sub-assembly (Click here).

  1. w/o Power Window:

    1. Remove the rear door trim board sub-assembly (Click here).


4. REMOVE REAR DOOR BELT MOULDING

  1. B114404E01
    Apply protective tape to the door panel in the area around the rear door belt moulding.

  1. B114405E01
    Using a moulding remover, disengage the 5 claws and the clip and remove the rear door belt moulding.


5. REMOVE REAR DOOR GLASS RUN

B116877
  1. Remove the rear door glass run.


6. REMOVE NO. 2 BLACK OUT TAPE

  1. B108314
    Using an infrared light, heat the No. 2 black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →