2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jan 2006

HINT:
The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B140700
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.


3. REMOVE REAR DOOR ARMREST BASE UPPER PANEL

B136205
  1. Disengage the 4 claws and remove the rear door armrest base upper panel.


4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B136206
    Remove the screw.

  1. B136207
    Disengage the 7 clips.

  1. w/ Power window:
    Disconnect the connector.

  1. B136208
    Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.


5. REMOVE REAR DOOR BELT MOULDING

  1. B134880E03
    Apply protective tape to the door panel in the periphery of the rear door belt moulding.

  1. B134881E02
    Using a moulding remover, disengage the 5 claws and remove the rear door belt moulding.


6. REMOVE REAR DOOR GLASS RUN

B136213
  1. Remove the rear door glass run.


7. REMOVE NO. 2 BLACK OUT TAPE

  1. B134885
    Using an infrared light, heat the No. 2 black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.

← COMPONENTS (from Jan 2006)INSTALLATION (from Jan 2006) →