INSTALLATION
Removal / installation · Vehicles built from Jan 2006
- HINT:
- The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.
| 1. INSTALL NO. 3 BLACK OUT TAPE |
Application precautions (Click here).
Clean the attachment surface (Using an infrared light) (Click here).
Clean the attachment surface (Using a tape removal disc) (Click here).
Apply new No. 1 black out tape to the positions shown in the illustration.


- Installation position:
Mark
Measurement (along surface)
a
-1 to 1 mm (-0.039 to 0.039 in.)
b
11 to 13 mm (0.433 to 0.512 in.)
c
10 to 12 mm (0.394 to 0.472 in.)
