2005-2008 Yaris · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2006

HINT:
  1. Use these procedures to troubleshoot the combination meter.
  2. Use the intelligent tester in steps 3 and 5.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM
    1. Use an intelligent tester to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here )

    2. Data List / Active Test (Click here )

    3. On-vehicle Inspection (Click here )

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Aug 2007)CUSTOMIZE PARAMETERS (from Jan 2006) →