2005-2008 Yaris · Service Manual BODY ELECTRICAL

Entire Combination Meter does not Operate

Circuit diagnosis · Vehicles built from Jan 2006

DESCRIPTION

This circuit provides power to the combination meter assembly.

WIRING DIAGRAM

E126919E01

INSPECTION PROCEDURE


1. CHECK FUSE (ECU-B, MET)

  1. E117120E01
    Remove the ECU-B fuse from the engine room relay block.

  1. Remove the MET fuse from the main body ECU.

  1. Measure the resistance.

    Standard resistance:
    Below 1Ω

  1. Reinstall the fuses.



NG
CHECK SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


2. INSPECT COMBINATION METER ASSEMBLY
E114496E06
  1. Disconnect the D1 combination meter assembly connector.

  1. Measure the resistance.

    Standard resistance:
    Terminal No.
    Condition
    Specified Condition
    D1-24 (ET) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Terminal No.
    Condition
    Specified Condition
    D1-1 (IG2) -
    Body ground
    Ignition switch ON
    10 to 14 V
    D1-2 (ECU-B) -
    Body ground
    Always
    10 to 14 V

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY


← U0129 Lost Communication with Skid Control ECU (from Jan 2006)Speedometer Malfunction (from Jan 2006) →