Speedometer Malfunction
Circuit diagnosis · Vehicles built from Jan 2006
DESCRIPTION
- w/o ABS:
The combination meter assembly controls the speedometer in accordance with vehicle speed signals from the speedometer sensor.
- w/ ABS:
The combination meter assembly controls the speedometer in accordance with vehicle speed signals from the brake actuator through the CAN communication system.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If DTC U0129 has been stored, troubleshoot the CAN communication system first.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SPEED METER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester on.
Perform the Active Test according to the prompts displayed on the tester.
- Combination Meter:
Item
Test Details
Diagnostic Note
Speed Meter Operation
0 / 40 (24) / 80 (48) / 120 (72) / 160 (96) / 200 (120) / 240 (144) km / (mph)
-
- OK:
- Vehicle speed displayed on the tester is approximately the same as that of the speedometer reading.
|
|
||||
| OK | |
| 2. CHECK BRAKE CONTROL SYSTEM |
Check the brake control system.
- Result:
Brake Control System
Proceed to
w/ ABS
A
w/o ABS
B
|
|
||||
| A | |
| 3. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED METER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester on.
Read the Data List according to the prompts displayed on the tester.
- Combination Meter:
Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
Vehicle Speed Meter
Vehicle speed /
Min.: 0 km/h (0mph),
Max.: 255 km/h (158mph)
Approximately same as actual vehicle speed (When vehicle is driven)
-
- OK:
- Vehicle speed displayed on the tester is approximately the same as the actual vehicle speed.
|
|
||||
| OK | ||
| ||
| 4. INSPECT SPEEDOMETER SENSOR |
Remove the speedometer sensor.

Connect the positive (+) lead from the battery to terminal 1 and the negative(-) lead to terminal 2.
Connect the positive (+) lead from the tester to terminal 3 and the negative (-) lead to terminal 2.
Rotate the shaft.
Check that the voltage output between terminals 2 and 3 varies between 0V and 11V.
Reinstall the speedometer sensor.
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (SPEEDOMETER SENSOR - COMBINATION METER ASSEMBLY) |
Disconnect the D1 combination meter assembly connector.

Disconnect the C23 speedometer sensor connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
D1-17 (SI) - C23-3 (SI)
Below 1 Ω
C23-2 (SE) - Body ground
Below 1 Ω
Reconnect the combination meter assembly connector.
Measure the voltage.
- Standard voltage:
Tester Connection
Condition
Specified Condition
C23-1 (IG+) - Body ground
Ignition switch ON
10 to 14V
Reconnect the speedometer sensor connector.
|
|
||||
| OK | ||
| ||
