2005-2008 Yaris · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. INSTALL INTERMEDIATE SHAFT OIL SEAL RING

C059959
  1. Coat a new intermediate shaft oil seal ring with ATF, and install it onto the intermediate shaft.


2. INSTALL FRONT CLUTCH DRUM O-RING

C059958
  1. Coat a new front clutch drum O-ring with ATF, and install it onto the clutch drum.


3. INSTALL FORWARD CLUTCH PISTON O-RING

C059957
  1. Coat a new forward clutch piston O-ring with ATF, and install it onto the intermediate shaft.


4. INSTALL CLUTCH DRUM SUB-ASSEMBLY

C059963
  1. Coat the clutch drum with ATF, and install it onto the intermediate shaft.


5. INSTALL FORWARD CLUTCH PISTON

C059964
  1. Coat the forward clutch piston with ATF, and install it onto the intermediate shaft.


6. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

C059954
  1. Coat the forward clutch return spring with ATF, and install it onto the intermediate shaft.


7. INSTALL CLUTCH BALANCER NO. 1
  1. Coat clutch balancer No. 1 with ATF, and install it onto the intermediate shaft.

  1. D025202E01
    Using SST, a press and snap ring pliers, install the snap ring.
    SST
    09387-00020  


8. INSTALL FRONT CLUTCH CLUTCH DISC

D025203E01
  1. Coat the 4 plates, 4 discs and flange with ATF, and install them onto the intermediate shaft with the snap ring.


9. INSTALL REVERSE CLUTCH DISC

D025204E01
  1. Coat the 2 plates, 2 discs and clutch flange with ATF, and install them with the snap ring onto the intermediate shaft.


10. INSPECT PACK CLEARANCE OF REVERSE CLUTCH

C059938
  1. Install the intermediate shaft onto the transaxle rear cover.

  1. Using a dial indicator, measure the clearance while applying compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard clearance:
    0.40 to 1.00 mm (0.0157 to 0.0394 in.)

    Flange thickness:
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    2
    3.2 mm (0.126 in.)
    3
    3.4 mm (0.135 in.)
    4
    3.6 mm (0.142 in.)


11. INSPECT PACK CLEARANCE OF FRONT CLUTCH

C059939E01
  1. Install the intermediate shaft onto the transaxle rear cover.

  1. Using a dial indicator and SST, measure the clearance while applying compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    SST
    09350-36010   (09350-06120)

    Standard clearance:
    1.3 to 1.5 mm (0.051 to 0.059 in.)

    Flange thickness:
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    2
    3.2 mm (0.126 in.)
    3
    3.4 mm (0.135 in.)
    4
    3.6 mm (0.142 in.)

← INSPECTION (from Aug 2005)COMPONENTS (from Aug 2005) →