2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

NOTICE:
Always use "Torx" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Luggage Compartment Room Light)

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B119913
    Remove the spare wheel cover.


5. REMOVE DECK FLOOR BOX (w/ Deck Board)
  1. for RH Side:

    1. Remove the deck floor box (Click here).

  1. for LH Side:

    1. Remove the deck floor box.

      HINT:
      Use the same procedure as for the RH side.


6. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

  1. B119912
    Remove the rear floor carpet.


7. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).


8. REMOVE NO. 2 REAR SEAT LEG COVER (for LH Side)

  1. B126921E01
    Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.


9. REMOVE REAR SEAT ASSEMBLY
  1. for RH Side:

    1. Remove the rear seat assembly (Click here).

  1. for LH Side:

    1. Remove the rear seat assembly (Click here).


10. REMOVE REAR DOOR SCUFF PLATE

  1. B114287
    Disengage the 6 claws and remove the rear door scuff plate.


11. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

  1. B114431
    Remove the rear door opening trim weatherstrip to the extent that the deck trim side panel and roof side inner garnish can be removed.


12. REMOVE REAR DECK TRIM COVER

  1. B117692
    for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.

  1. B114283
    for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.


13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY

  1. B114289
    Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.

  1. B114454
    Remove the bolt.

  1. Disengage the clip and remove the anchor plate of the rear seat outer belt.

  1. B114573
    for RH Side (w/ Package Tray Trim):

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.

  1. B114290
    for RH Side (w/o Package Tray Trim):

    1. Remove the 2 screws.

    2. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.

  1. B114574
    for LH Side (w/ Package Tray Trim):

    1. Remove the 3 screws.

    2. w/ Luggage Compartment Room Light:

      1. Disengage the 3 clips and the 6 claws.
      2. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    3. w/o Luggage Compartment Room Light:

      1. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.

  1. B114291
    for LH Side (w/o Package Tray Trim):

    1. Remove the 2 screws.

    2. w/ Luggage Compartment Room Light:

      1. Disengage the 4 clips and the 6 claws.
      2. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    3. w/o Luggage Compartment Room Light:

      1. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.


14. REMOVE REAR SEAT SHOULDER BELT HANGER

  1. B114433E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat shoulder belt hanger.


15. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for 3 Point Type Rear Center Seat Belt)

  1. B114462E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.


16. REMOVE ROOF SIDE INNER GARNISH

  1. B114576E01
    for RH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. for 3 Point Type Rear Center Seat Belt:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

    2. for 2 Point Type Rear Center Seat Belt:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114575
    for RH Side (w/o Curtain Shield Airbag):

    1. for Rear Center Seat Belt 3 Point Type:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt and rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

    2. for Rear Center Seat Belt 2 Point Type:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114578E01
    for LH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114577
    for LH Side (w/o Curtain Shield Airbag):

    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.


17. REMOVE REAR SEAT OUTER BELT ASSEMBLY

  1. B114434
    Remove the bolt and the through anchor.

  1. B114435
    Remove the bolt, the 2 hooks and the retractor.


18. REMOVE SEAT BELT HOLE SEAL

  1. B114436
    Disengage the 2 claws and remove the seat belt hole seal.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →