2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B119870
    Remove the front seat under tray.


3. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B138677E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


4. REMOVE FRONT SEAT ASSEMBLY

  1. B119871E01
    Disconnect the buckle switch connector.

  1. w/ Front Seat Side Airbag:

    1. Disconnect the airbag connector.

      1. Slide the slider and disconnect the airbag connector.

  1. B119872
    Using "Torx" socket wrench E10, remove the 4 bolts and front seat.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. B127001
    for Drive Side:

    1. Disengage the 2 hooks and remove the front seat cushion cover.

    2. Remove the buckle switch connector.

    3. w/ Seat Heater System:

      1. Disconnect the seat heater connector.

    4. Remove the 4 clamps.

    5. B114766
      Remove the wire harness from the claw of the front seat cushion shield.

    6. Remove the bolt and the front seat inner belt.

  1. B127000
    for Front Passenger Side:

    1. Disengage the 2 hooks and remove the front seat cushion cover.

    2. Disconnect the occupant detection sensor connector.

    3. w/ Seat Heater System:

      1. Disconnect the seat heater connector.

    4. Remove the buckle switch connector.

    5. Remove the 5 clamps.

    6. B114762
      Remove the wire harness from the claw of the front seat cushion shield.

    7. Remove the bolt and the front seat inner belt.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →