INSPECTION
Inspection · Vehicles built from Aug 2005
- HINT:
- The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.
| INSPECT FRONT SEAT INNER BELT ASSEMBLY |
for Driver Side:

Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Tongue plate fastened
10 kΩ or higher
Tongue plate released
Below 1 Ω
- Using an ohmmeter, measure the resistance between the terminals.
for Front Passenger Side:

Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A1 - B1
Tongue plate fastened
10 kΩ or higher
Tongue plate released
Below 1 Ω
A2 - B1
Always
Below 1 Ω
- Using an ohmmeter, measure the resistance between the terminals.
