2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

NOTICE:
Always use "Torx" socket wrench E10 when installing the rear seat.


1. INSTALL REAR CENTER SEAT INNER BELT ASSEMBLY

  1. B127751E01
    Install the rear center seat inner belt with the nut.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not place the anchor plate over the convex areas of the rear seat frame adjuster.


2. INSTALL REAR SEAT RECLINING INNER COVER

  1. B127749E01
    Pass the rear center seat inner belt through the slit in the rear seat reclining inner cover.

  1. Engage the claw and install the rear seat reclining inner cover.

  1. Using "Torx" socket wrench T25, tighten the screw.

  1. Install the belt of the rear center seat inner belt into the rear seatback band.


3. INSTALL REAR SEAT CUSHION UNDER COVER

  1. B124344
    Engage the 6 claws and install the rear seat cushion under cover.

  1. B124343
    Engage the 4 clips and install the rear seatback cover.


4. INSTALL REAR SEAT ASSEMBLY

  1. B124363E01
    Insert the 2 locating pins through the 2 body holes and install the rear seat.

  1. Using "Torx" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. B124331E01
    Install the rear seat cushion.

  1. Using "Torx" socket wrench E10, install the 3 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }


5. INSTALL REAR SEAT LEG COVER

  1. B124330
    Engage the 6 claws and install the No. 2 rear seat leg cover.


6. INSTALL DECK FLOOR BOX (w/ Deck Board)

  1. B106445
    Install the deck floor box and lock the 2 knobs.


7. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B138393
    Install the spare wheel cover.


8. INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106447
    Set the deck board and lock the 2 knobs.


9. INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

  1. B138392
    Install the rear floor carpet.


10. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Engage the 2 claws and install the package tray trim panel.

  1. Install the 5 pieces of hook tape.

  1. Install the 2 package tray trim suspenders.

← REMOVAL (from Nov 2005)COMPONENTS (from Jan 2006) →