2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when installing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.


1. INSTALL FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)

  1. B119876
    w/ Seat Heater System:

    1. Connect the seat heater connector.

    2. Engage the 2 claws and the 9 hooks and install the front seat cushion cover pad.

  1. w/o Seat Heater System:

    1. Engage the 2 claws and the 9 hooks and install the front seat cushion cover pad.

  1. Install the occupant detection sensor connector.

  1. B114700E01
    w/ Front Seat Side Airbag:

    1. Fix the front seat side airbag wiring harness with the front seat cushion cover pad fixing cover.

  1. for Clip Type:

    1. Install the 2 clips.

  1. for J Hook Type:

    1. Engage the 2 hooks.

  1. B119875
    Install the front seatback cover band.


2. INSTALL FRONT SEAT CUSHION SHIELD LH

  1. B121711
    Engage the claw and the clip and install the front seat cushion shield.

  1. Tighten the screw.


3. INSTALL FRONT SEAT INNER BELT ASSEMBLY

  1. B114763E01
    Install the front seat inner belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

  1. Install the wiring harness onto the claw of the front seat cushion shield.

  1. B127000
    Install the 5 wiring harness clamps.

  1. Install the buckle switch connector.

  1. Connect the occupant detection sensor connector.

  1. w/ Seat Heater System:

    1. Connect the seat heater connector.

  1. Engage the 2 hooks and install the front seat cushion cover pad.


4. INSTALL FRONT SEAT CUSHION SHIELD RH

  1. B121710
    Engage the 2 claws and the clip and install the front seat cushion shield.

  1. Tighten the screw.


5. INSTALL RECLINING ADJUSTER RELEASE HANDLE

  1. B121712
    Engage the claw and install the reclining adjuster release handle.


6. INSTALL FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side (Click here).


7. INSTALL FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B119884
    Hitch the front seat under tray firmly onto the seat track, and then slide it along the seat track to install it.


8. INSTALL FRONT SEAT HEADREST ASSEMBLY

  1. B138677E01
    Push in the 2 lock buttons of the front seat headrest supports and install the 2 front seat headrests.


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


10. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)
← INSPECTION (from Aug 2005)COMPONENTS (from Nov 2005) →