REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() ![]() |
Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.
Disengage the 3 claws and 9 clips and remove the back door trim board.

| 3. REMOVE BACK DOOR LOCK ASSEMBLY |
![]() ![]() |
Disconnect the connector and the clamp.
Remove the 3 bolts and the back door lock.
| 4. REMOVE BACK DOOR LOCK ACTUATOR ASSEMBLY (w/o Entry and Start System) |
![]() ![]() |
Disconnect the connector.
Remove the 2 bolts and the back door lock actuator.



