2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1443/43 Air Outlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier . The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the mode damper to the appropriate position, which controls the air outlet modes.

HINT:
Confirm that there are no mechanical problems because this DTC can be output when either a damper link or damper is mechanically locked.
DTC No.
DTC Detection Condition
Trouble Area
B1443/43
Air outlet damper position does not change even if air conditioner amplifier operates air outlet damper control servo motor
  1. Air outlet control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier


WIRING DIAGRAM

E115806E06

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR OUT PULSE-D)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.

  1. Select the items below in the Data List, and read the value displayed on the intelligent tester.

    Data List / Air Conditioner:
    ITEM
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Air Out Pulse-D
    Driver side air outlet servo motor target pulse /
    Min.: 0, Max.: 255
    9 appears when DEF switch is pressed, and value changes between 35 and 101 in accordance with MODE switch operation
    -

    HINT:
    Reference values
    1. Air outlet mode FACE: 101
    2. Air outlet mode BI-LEVEL: 74
    3. Air outlet mode FOOT: 53
    4. Air outlet mode FOOT/DEF: 35
    5. Air outlet mode DEF: 9

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2. REPLACE AIR OUTLET CONTROL SERVO MOTOR

HINT:
Since the servo motor cannot be tested when it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.

OK:
Same problem does not occur.



NG
REPLACE AIR CONDITIONING HARNESS
OK

SYSTEM IS OK


← B1442/42 Air Inlet Damper Control Servo Motor Circuit (from Aug 2005)B1451/51 Compressor Solenoid Circuit (from Aug 2005) →