B1451/51 Compressor Solenoid Circuit
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier.Based on this signal, the compressor changes the degree of refrigerant compression.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1451/51 |
Open or short in solenoid of externally changeable compressor circuit |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (REG CTRL CURRNT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.
Select the items below in the Data List, and read the value displayed on the intelligent tester.
- Data List / Air Conditioner:
ITEM
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Reg Ctrl Currnt
Regulator control current /
Min.: 0 A
Max.: 0.997 A
Value changes between 0A and 0.997A in accordance with compressor and pulley operation
-
- OK:
- The display is as specified in the normal condition column.
- Result:
Result
Proceed to
NG
A
OK (Checking from the PROBLEM SYMPTOMS TABLE)
B
OK (Checking from the DTC)
C
|
|
||||
|
|
||||
| A | |
| 2. INSPECT COMPRESSOR AND PULLEY |
![]() ![]() |
Disconnect the the compressor and pulley connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
C8-1 - C8-2
10.1 to 11.1 Ω at 25°C (77°F)
Reconnect the compressor and pulley connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (COMPRESSOR AND PULLEY - AIR CONDITIONING AMPLIFIER) |
![]() ![]() |
Disconnect the C8 compressor and pulley connector.
Disconnect the E11 air conditioning amplifier connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
C8-1 - E11-2 (SOL+)
Below 1 Ω
C8-1 - Body Ground
1MΩ or higher
Reconnect the compressor and pulley connector.
Reconnect the air conditioning amplifier connector.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (COMPRESSOR AND PULLEY - BODY GROUND) |
![]() ![]() |
Disconnect the C8 compressor and pulley connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
C8-2 - Body Ground
Below 1 Ω
Reconnect the compressor and pulley connector.
|
|
||||
| OK | ||
| ||



