INSTALLATION
Removal / installation · Vehicles built from Aug 2005
- NOTICE:
- Always use "Torx" socket wrench E10 when installing the rear seat.
| 1.
INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY |
 |
- Install the rear seat cushion leg sub-assembly with the 2 bolts.
-
Torque:
- 37 N*m{
375 kgf*cm
, 27 ft.*lbf
}
| 2.
INSTALL REAR SEAT BACK ASSEMBLY |
 |
- Insert the 2 location pins through the 2 body holes and install the rear seat back.
Using "Torx" socket wrench E10, tighten the 4 bolts.
-
Torque:
- 37 N*m{
375 kgf*cm
, 27 ft.*lbf
}
| 3.
INSTALL REAR SEAT CUSHION LOCK HOOK |
 |
- Engage the 4 claws and install the 2 rear seat cushion lock hooks.
| 4.
INSTALL REAR SEAT CUSHION COVER PAD |
 |
- Pass the rear seat inner belt through the slit in the rear seat cushion.
Engage the 3 hooks and install the rear seat cushion.
- NOTICE:
- Make sure that the rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.
| 5.
INSTALL DECK FLOOR BOX RH
|
 |
- Set the deck floor box and lock the 2 knobs.
| 6.
INSTALL DECK FLOOR BOX LH
|
 |
- HINT:
- Use the same procedure as for the RH side.
| 7.
INSTALL DECK BOARD SUB-ASSEMBLY
|
 |
- Set the deck board and lock the 2 knobs.
| 8.
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
|
 |
- Engage the 2 claws and install the package tray trim panel.
Install the 5 pieces of hook tape.
Install the 2 package tray trim suspenders.