REASSEMBLY
Removal / installation · Vehicles built from Aug 2005
- CAUTION:
- Wear protective gloves. Sharp surfaces on the front seat back frame could cause injuries to your hands.
| 1. INSTALL REAR SEAT LEG SUB-ASSEMBLY |
Install the rear seat leg with the 4 bolts.

- Torque:
- 44 N*m{ 449 kgf*cm , 33 ft.*lbf }
| 2. INSTALL REAR SEAT RECLINING CONTROL CABLE |
Install the 2 clamps.

Install the rear seat reclining control cable as shown in the illustration.

| 3. INSTALL RECLINING ADJUSTER LOWER INSIDE COVER RH |
Install the reclining adjuster lower inside cover with the clip.

| 4. INSTALL RECLINING ADJUSTER LOWER INSIDE COVER LH |
- HINT:
- Use the same procedure as for the RH side.
| 5. INSTALL REAR SEAT RECLINING COVER RH |
Engage the 7 claws and install the rear seat reclining cover.

Tighten the screw.
| 6. INSTALL REAR SEAT RECLINING COVER LH |
- HINT:
- Use the same procedure as for the RH side.
| 7. INSTALL REAR SEAT BACK COVER PAD |
Install the rear seat back cover pad.

Fasten the 2 zippers.

Engage the hook.

| 8. INSTALL REAR SEAT HEADREST SUPPORT |
Align the protruding portions of the rear seat headrest support with the installation grooves of the rear seat back frame.

Engage the 8 claws and install the 4 rear seat headrest supports.
| 9. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY |
Connect the rear seat reclining control cable and install the rear seat lock control lever.

Tighten the 2 screws.
| 10. INSTALL REAR SEAT BACK LOCK STRIKER COVER |
Engage the 2 claws and install the rear seat back lock striker cover.

| 11. INSTALL REAR SEAT HEADREST ASSEMBLY |
Push in the 2 lock buttons of the 2 rear seat headrest supports and install the 2 rear seat headrests.

