2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL STARTER ASSEMBLY

A104533
  1. Install the starter assembly with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Connect the connector.

  1. Connect terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7.2 ft.*lbf }

  1. Close the terminal cap.

  1. A115443
    Install the wire harness bracket with the bolt.

    Torque:
    8 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. A115442
    Install the harness clamp.


2. INSTALL FLYWHEEL HOUSING SIDE COVER

A104532E04
  1. Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

    NOTICE:
    1. Make sure that the claw makes a click sound, indicating that it fits tightly.
    2. Replace the claw with a new one if it does not fit tightly or is deformed.


3. INSTALL BATTERY TRAY

4. INSTALL BATTERY

A104324
  1. Install the battery onto the battery tray.

  1. Install the battery carrier clamp with the nut.

  1. Install the positive and negative terminals.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Aug 2005)COMPONENTS (from Nov 2005) →