INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT REAR BRAKE DRUM INSIDE DIAMETER |
![]() ![]() |
Using a brake drum gauge or the equivalent, measure the inside diameter of the brake drum.
- Standard inside diameter:
- 200 mm (7.874 in.)
- Maximum inside diameter:
- 201 mm (7.913 in.)
| INSPECT REAR BRAKE SHOE LINING THICKNESS |
![]() ![]() |
Using a ruler, measure the thickness of the shoe lining.
- Standard thickness:
- 4.0 mm (0.157 in.)
- Minimum thickness:
- 1.0 mm (0.039 in.)
- NOTICE:
- If the brake shoes need replacing, they must be replaced as a set.
| INSPECT REAR BRAKE DRUM AND REAR BRAKE SHOE LINING FOR PROPER CONTACT |
![]() ![]() |
Apply chalk to the inside surface of the drum, then grind the brake shoe lining so that they fit together properly.
If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.
| INSPECT WHEEL BRAKE CYLINDER |




