2005-2008 Yaris · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. INSTALL REAR WHEEL CYLINDER KIT

F044261E02
  1. Apply lithium soap base glycol grease to 2 new wheel cylinder cups and the 2 pistons.

  1. Install the wheel cylinder cup onto each piston.

  1. Install the compression spring and 2 pistons onto the wheel brake cylinder.

  1. Install 2 new wheel cylinder boots onto the wheel brake cylinder.


2. INSTALL REAR WHEEL BRAKE CYLINDER ASSEMBLY

C108975
  1. Install the wheel brake cylinder with the bolt.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }

  1. Provisionally install the bleeder plug.

  1. Install the bleeder plug cap.

  1. C108974E01
    Using SST, install the brake tube.
    SST
    09023-00100  

    Torque:
    for use without SST:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }
    for use with SST:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.


3. INSTALL REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY

C062256
  1. Using needle-nose pliers, install the parking brake shoe lever with a new C-washer.


4. INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER

C062254
  1. Install the automatic adjust lever and automatic adjust lever tension spring onto the front brake shoe.


5. INSTALL REAR BRAKE SHOE KIT

C116953E01
  1. Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.

  1. C108972
    Using needle-nose pliers, install the parking brake cable onto the parking brake shoe lever.

  1. C108971E01
    Using SST, install the rear brake shoe, pin, shoe hold down spring and shoe hold down spring cup.
    SST
    09718-00010  

  1. F050549E01
    Apply high temperature grease to the adjusting bolt.

  1. F040013E01
    Install the parking brake shoe strut set as shown in the illustration.

  1. C108969E01
    Using SST, install the front brake shoe, pin, shoe hold down spring and shoe hold down spring cup.
    SST
    09718-00010  

  1. F042698
    Using needle-nose pliers, install the tension spring onto the front brake shoe and rear brake shoe.

  1. C108968E01
    Using SST, install the shoe return spring onto the front brake shoe.
    SST
    09703-30010  

    NOTICE:
    Do not damage the wheel cylinder boot.


6. CHECK REAR DRUM BRAKE INSTALLATION

  1. Check that each part is installed properly.

    C108977E01

  1. C116892
    Measure the brake drum inner diameter and the diameter of the brake shoes. Check that the difference between the diameters is equal to the specified shoe clearance.

    Shoe clearance:
    0.6 mm (0.024 in.)

    NOTICE:
    There should be no oil or grease adhering to the friction surfaces of the shoe lining or the drum.

← INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →