2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK RADIATOR CAP SUB-ASSEMBLY

A107446E01

  1. Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.

    2. Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.

    3. Check that rubber packings 3 and 4 are not stuck together.

    4. Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.

    5. When using the cap tester, tilt it to more than 30 degrees.

    6. A104601E03
      Pump the cap tester several times, and check the maximum pressure *1.

      Pumping speed:
      1 pumps per second

      *1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment Criterion:
      Item
      Specified Condition
      Standard valve
      (for brand-new cap)
      93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
      Minimum standard valve
      (after using cap)
      78.5 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the specified pressure for the minimum standard valve, replace the radiator cap sub-assembly.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →