ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| CHECK RADIATOR CAP SUB-ASSEMBLY |
![]() ![]() |
Measure the valve opening pressure.
If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.
Check that O-ring 1 is not deformed, cracked or swollen.
Apply engine coolant to O-ring 1 and rubber packing 2 before using the radiator cap tester.
When using the cap tester, tilt it to more than 30 degrees.
Pump the cap tester several times, and check the maximum pressure *1.

- Pumping speed:
- 1 pumps per second
- Judgment Criterion:
Item
Specified Condition
Standard valve
(for brand-new cap)
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard valve
(after using cap)
78.5 kPa (0.8 kgf/cm2, 11.38 psi)

