REMOVAL
Removal / installation · Vehicles built from Nov 2005
- CAUTION:
- Be sure that the ignition is off if you work near the electric cooling fans or radiator grille. With the ignition on the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler) |
Remove the 5 screws and the front spoiler cover.

| 3. REMOVE FRONT SPOILER COVER RH (w/ Front Spoiler) |
Remove the 4 screws and the front spoiler cover.

| 4. REMOVE FRONT BUMPER COVER |
Apply protective tape as shown in the illustration.

w/ Front Spoiler:

Remove the 3 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/o Front Spoiler:

Remove the 8 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/ Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
w/ Front Spoiler:

Remove the 2 clips and the 4 screw grommets.
w/o Front Spoiler:

Remove the 2 clips and the screw grommet.
| 5. REMOVE ENGINE UNDER COVER |
Remove the 5 bolts, 4 screws and 2 clips and remove the engine under cover.
| 6. REMOVE AIR CLEANER ASSEMBLY |
Disconnect the mass air flow meter connector.

Disengage the 2 clamps, and separate the wire harness from the air cleaner cap.
Unfasten the 2 lock clamps, and separate the air cleaner cap.

Loosen the hose clamp, and remove the air cleaner cap.
Remove the air cleaner element.

Remove the 3 bolts and air cleaner case.

| 7. REMOVE RADIATOR RESERVE TANK ASSEMBLY |
![]() ![]() |
Loosen the clip and separate water by-pass hose No. 4.
Loosen the clip and separate water by-pass hose No. 5.
Remove water by-pass hose No. 5 from the fan shroud.
Remove the bolt and remove the radiator reserve tank.
| 8. REMOVE HOOD LOCK ASSEMBLY |
Remove the 3 bolts, and separate the hood lock.

Separate the hood lock control cable from the radiator support upper.

| 9. REMOVE RADIATOR SUPPORT UPPER |
Disconnect the horn connector.

Disengage the clamp, and separate the wire harness.
Remove the 4 bolts and radiator support upper.
| 10. DISCONNECT AIR HOSE NO. 3 |
Loosen the hose clamp, and disconnect air hose No. 3.

| 11. DISCONNECT AIR HOSE NO. 2 |
Loosen the hose clamp, and disconnect air hose No. 2.

| 12. REMOVE INTERCOOLER ASSEMBLY |
Disengage the 2 clamps, and separate the wire harness.
Disconnect the hose.

Remove the intercooler.

Remove the radiator support cushion.
Remove the 2 grommets.
| 13. DISCONNECT RADIATOR HOSE NO. 1 |
![]() ![]() |
Loosen the clip and disconnect radiator hose No. 1.
| 14. DISCONNECT RADIATOR HOSE NO. 2 |
![]() ![]() |
Loosen the clip and disconnect radiator hose No. 2.
| 15. REMOVE COOLER REFRIGERANT LIQUID PIPE E (TO COOLER UNIT) (w/ Air Conditioning System) |
![]() ![]() |
Remove the bolt and separate the cooler refrigerant liguid pipe from the fan shroud.
| 16. REMOVE RADIATOR ASSEMBLY (w/ Air Conditioning System) |
![]() ![]() |
Disengage the clamp and remove the turbo pressure sensor from the fan shroud.
Separate the cooling fan motor connector and wire harness clamp.
Remove the vacuum transmitting pipe from the fan shroud.

Disengage the 2 claws and remove the radiator assembly from the vehicle.

- NOTICE:
- Do not apply excessive force to the cooler condenser assembly or piping when removing the radiator assembly.
| 17. REMOVE RADIATOR ASSEMBLY (w/o Air Conditioning System) |
![]() ![]() |
Disengage the clamp and remove the turbo pressure sensor from the fan shroud.
Separate the cooling fan motor connector and wire harness clamp.
Remove the vacuum transmitting pipe from the fan shroud.

Remove the radiator assembly from the vehicle.
| 18. REMOVE WATER BY-PASS HOSE NO. 4 |
![]() ![]() |
Loosen the clip and remove water by-pass hose No. 4.
| 19. REMOVE FAN SHROUD NO. 2 |
![]() ![]() |
Disengage the 2 claws and remove fan shroud No. 2.
| 20. REMOVE RADIATOR SUPPORT CUSHION |
![]() ![]() |
Remove the 2 radiator support cushions from the radiator assembly.
| 21. REMOVE RADIATOR RESERVE TANK HOSE GROMMET |
![]() ![]() |
Remove the 2 radiator reserve tank hose grommets from the radiator assembly.









