2005-2008 Yaris · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP

C128940
  1. Using needle-nose pliers, disengage the hook and remove the boot clamp.


2. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP

C128941
  1. Using pliers, remove the boot clamp, as shown in the illustration.


3. SEPARATE FRONT AXLE INBOARD JOINT BOOT
  1. Separate the inboard joint boot from the inboard joint.


4. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
  1. Remove the old grease from the inboard joint.

  1. C128942E01
    Place matchmarks on the inboard joint and outboard joint shaft.

    NOTICE:
    Do not cause any damage when placing the marks.

  1. Remove the inboard joint from the outboard joint shaft.

  1. Fix the outboard joint shaft in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C130325E01
    Using a snap ring expander, remove the snap ring.

  1. F047435E01
    Place matchmarks on the tripod joint and outboard joint shaft.

    NOTICE:
    Do not cause any damage when placing the marks.

  1. Using a brass bar and hammer, remove the tripod joint.

    NOTICE:
    Do not tap the roller.

  1. Remove the inboard joint boot No. 2 clamp, the inboard joint boot and the inboard joint boot clamp.


5. REMOVE FRONT DRIVE SHAFT DAMPER CLAMP (for RH Side)

C128943E01
  1. Using pliers, remove the damper clamp, as shown in the illustration.


6. REMOVE FRONT DRIVE SHAFT DAMPER (for RH Side)

7. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP

C128944
  1. Using pliers, remove the boot clamp, as shown in the illustration


8. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP

C128945
  1. Using pliers, remove the boot clamp, as shown in the illustration.


9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft.

  1. Remove the old grease from the outboard joint.


10. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING

C057543
  1. Using a screwdriver, remove the snap ring.


11. REMOVE FRONT DRIVE SHAFT DUST COVER

F047437E01
  1. Using SST and a press, remove the dust cover.

    SST
    09950-00020  

    NOTICE:
    Do not drop the inboard joint.

← REMOVAL (from Nov 2005)REASSEMBLY (from Nov 2005) →