ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2006
| CHECK RADIATOR CAP SUB-ASSEMBLY |
![]() ![]() |
Measure the valve opening pressure.
If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.
Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.
Check that rubber packings 3 and 4 are not stuck together.
Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.
When using the cap tester, tilt it to more than 30 degrees.
Pump the cap tester several times, and check the maximum pressure *1.

- Pumping speed:
- 1 pump per second
- Judgment criteria:
Item
Specified Condition
Standard valve
(for brand-new cap)
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard valve
(after using cap)
78.5 kPa (0.8 kgf/cm2, 11.4 psi)

