2005-2008 Yaris · Service Manual BODY

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH FRONT

  1. B118062E01
    w/ Jam protection function:
    Check the operation of the regulator motor.

    NOTICE:
    1. Do not apply voltage to any terminals of the motor, except terminal 2, to avoid damaging the pulse sensor inside the motor.
    2. Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door (Click here).


    1. Apply battery voltage to the regulator motor and check the operation of the regulator motor.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1, 4 and 10
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1 and 7
      Motor gear rotates counterclockwise

      If the result is not as specified, replace the power window regulator motor.

  1. B121541E01
    w/o Jam protection function:
    Check the operation of the regulator motor.

    1. Apply battery voltage to the regulator motor and check the operation of the regulator motor.

      Standard:
      Measurement condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Motor gear rotates counterclockwise

      If the result is not as specified, replace the power window regulator motor.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH FRONT

  1. B121542E01
    w/ Jam protection function:
    Check the operation of the regulator motor.

    NOTICE:
    1. Do not apply voltage to any terminals of the motor, except terminal 2, to avoid damaging the pulse sensor inside the motor.
    2. Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door (Click here).


    1. Apply battery voltage to the regulator motor and check the operation of the regulator motor.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1 and 7
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1,4 and 7
      Motor gear rotates counterclockwise

      If the result is not as specified, replace the power window regulator motor.

  1. B121543E01
    w/o Jam protection function:
    Check the operation of the regulator motor.

    1. Apply battery voltage to the regulator motor and check the operation of the regulator motor.

      Standard:
      Measurement Condition
      Specified Condition
      Battery position (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Motor gear rotates clockwise
      Battery position (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Motor gear rotates counterclockwise

      If the result is not as specified, replace the power window regulator motor.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →