REMOVAL
Removal / installation · Vehicles built from Aug 2005
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System) |
![]() ![]() |
Disengage the 4 claws and remove the steering column cover support.
| 3. REMOVE STEERING COLUMN COVER |
![]() ![]() |
Turn the steering wheel 90 degrees in both directions and remove the 2 screws.
Remove the screw from the lower portion of the steering cover lower.
Disengage the 2 claws and remove the steering column cover lower.
| 4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY LH |
Remove the 2 screws.

Disengage the 3 claws and remove the instrument panel under cover.
| 5. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY |
![]() ![]() |
Remove the 4 screws.
Disengage the 6 claws and remove the driver side knee airbag assembly.
Using a thin-bladed screwdriver, release the locking button.
Using a thin-bladed screwdriver, disconnect the airbag connector and remove the instrument panel wire.



