2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE RH

  1. B114284
    Disengage the 8 claws and remove the front door scuff plate.


3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

B114286
  1. Remove the front door opening trim weatherstrip to the extent necessary to remove the center pillar garnish.


4. REMOVE REAR DOOR SCUFF PLATE RH

  1. B114287
    Disengage the 6 claws and remove the rear door scuff plate.


5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

B114288
  1. Remove the rear door opening trim weatherstrip to the extent necessary to remove the center pillar garnish.


6. REMOVE CENTER PILLAR LOWER GARNISH RH

7. REMOVE SIDE AIRBAG SENSOR ASSEMBLY

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. B106572E01
    Slide the outer housing and detach the airbag connector.

  1. B106573E01
    Remove the bolt, disengage the hook and remove the side airbag sensor.

← ON-VEHICLE INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →