2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. B106573E01
    Insert the hook into the body hole and install the airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Do not use a side airbag sensor that has been dropped.
    2. Do not subject the side airbag sensor to any impact or force.

  1. Confirm that there is no looseness by shaking the side airbag sensor.

  1. B106574E01
    Connect the airbag connector.


2. INSTALL CENTER PILLAR LOWER GARNISH RH

  1. B114297
    Engage the 2 clips and the 2 claws and install the center pillar lower garnish.


3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

B114288
  1. Install the rear door opening trim weatherstrip.


4. INSTALL REAR DOOR SCUFF PLATE RH

  1. B114287
    Engage the 6 claws and install the rear door scuff plate.


5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

B114286
  1. Install the front door opening weatherstrip.


6. INSTALL FRONT DOOR SCUFF PLATE RH

  1. B114284
    Engage the 8 claws and install the front door scuff plate.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


8. INSPECT SRS WARNING LIGHT
(Click here)
← REMOVAL (from Aug 2005)COMPONENTS (from Aug 2005) →