2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Borad)

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B119913
    Remove the spare wheel cover.


5. REMOVE DECK FLOOR BOX RH (w/ Deck Borad)

  1. B106372
    Release the 2 knobs and remove the deck floor box.


6. REMOVE DECK FLOOR BOX LH (w/ Deck Board)

HINT:
Use the same procedure as for the RH side.


7. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).


8. REMOVE NO. 2 REAR SEAT LEG COVER

  1. B126921E01
    Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.


9. REMOVE REAR SEAT ASSEMBLY RH

  1. B114660
    Using "Torx" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.

  1. B119885
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


10. REMOVE REAR SEAT ASSEMBLY LH

HINT:
Use the same procedure as for the RH side.


11. REMOVE FRONT DOOR SCUFF PLATE RH

  1. B114494
    Disengage the 8 claws and remove the front door scuff plate.


12. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  1. B114286
    Remove the rear opening trim weatherstrip to the extent necessary to remove the deck trim panel side.


13. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY RH (for Sill Bar Type)

  1. B114759
    Remove the 2 bolts and the front seat outer belt bar.


14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

  1. B114498
    Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.

  1. B114499
    Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.


15. REMOVE REAR DECK TRIM COVER

  1. B117692
    for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.

  1. B114283
    for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.


16. REMOVE DECK SIDE TRIM PANEL ASSEMBLY RH

  1. C123148E01
    Remove the 3 screws.

  1. Disengage the 3 clips and the 3 claws and remove the deck side trim panel.

    HINT:
    When removing the deck trim side panel assembly LH from the vehicle with the luggage compartment room light, connector and then remove the deck trim side panel assembly.


17. REMOVE REAR AIRBAG SENSOR

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. B106579E01
    Slide the outer housing and detach the airbag connector.

  1. B106578E01
    Disengage the bolt and hook and remove the airbag sensor.

← ON-VEHICLE INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →